AUTONET TV

Making Sense of the O2 Sensor (Oxygen Sensor Replacement)

As you know, today’s vehicles rely on a lot of computers in them to keep them running clean and efficiently.  Those computers depend on information delivered by several sensors throughout the engine and exhaust system.  And one of the most important is the oxygen sensor.  

Known as the O2 sensor for short, it looks for too much unburned oxygen that has made it into the exhaust. That signals something isn’t right with the engine’s air-fuel mixture.  The sensor sends signals to the engine’s computers, which can then make adjustments to make sure the engine is running as it was designed to.

Some vehicles can have several O2 sensors, and since they can measure oxygen at various points in the combustion/exhaust process, the computers can pinpoint where the problems lie.  For example, an O2 sensor can detect how much oxygen is coming out of the engine’s combustion chamber, and another one can measure oxygen coming out of the catalytic converter.

As you can see, it’s important that those O2 sensors are working correctly.  If they’re not, the computer is getting bad information.  Garbage in, garbage out. That can result in lousy fuel economy and excess pollution coming out of your tailpipe. It can also affect your vehicle’s performance.  Sometimes your Check Engine light will illuminate when one of your O2 sensors goes bad.  Or you may notice your engine misfiring or idling roughly. 

If you notice any of these symptoms, bring your vehicle on in, and a technician will pinpoint the trouble spot.  

Kingwood Service Center
3318 Northpark Dr
Kingwood, TX 77339
(281) 360-7323
http://www.kingwoodservicecenter.net

How Cool is That! (Coolant level sensor replacement)

Your vehicle’s engine runs hot.  It should, since it’s a series of little explosions that create the power that gets you going where you want to go.  To keep the engine cool, engineers have designed wonderful cooling systems that use liquid coolant, hoses, and a radiator to transfer the heat from the engine to the outside air. 

In order for the system to work right, it has to have the right amount of that liquid coolant in it.  So that you know when the coolant has dipped below the correct amount, there is a sensor that keeps an eye on it.  When the coolant gets low, that sensor lights up a signal on the dash to alert you.  It may literally say “Check Coolant” or it may have a picture that looks like an old-style bulb thermometer sitting in liquid.  Your owner’s manual will usually tell you exactly what the one in your vehicle looks like.

If that sensor system isn’t working right, you could wind up driving for a long time with not enough coolant in the engine, and the excess heat can cause some extensive—and expensive—damage. 

There are a couple of ways you will know if something’s wrong with your coolant level sensor.  One is when you top off the coolant tank, and the low coolant light stays on.  If you suspect yours might be having a problem, bring it in so we can thoroughly check your coolant system.

If it is a sensor, we can run a test to see where the problem is in your cooling system.  It could be a bad sensor, but it also could be that there is something causing your coolant level to be low.  If the sensor needs replacing, the technician will replace it, fill your coolant level to the manufacturer’s recommended level, and test for any leaks in the system.  Really, how cool is that?

Kingwood Service Center
3318 Northpark Dr
Kingwood, TX 77339
(281) 360-7323
http://www.kingwoodservicecenter.net

test

Beware of Potholes! (Avoiding Pothole Damage)

You may live in a region where roads become pockmarked with craters known better as potholes.  They're caused by moisture seeping through a compromised road surface that can freeze, expand and literally punch holes in the road.  And when your vehicle hits one of those holes that's big enough, the impact can flatten a tire, bend a wheel or tear apart a suspension component. 

To minimize pothole damage, leave enough room between you and the vehicle in front of you so you can see the road surface and any upcoming potholes.  That way you'll have time to slow down and steer around them.  Also, if you see what looks like a puddle of water, it may be hiding a pothole underneath, so treat it as if was a pothole.

If you keep your tires inflated to the manufacturer's specifications, they're more likely to withstand hard impacts.  And the slower you're going when you hit a pothole, the less likely you are to break something.   But if you do find you've hit a pothole pretty hard, here are some signs to watch out that could signal damage.

• Your vehicle pulls to one side
• The steering wheel shakes
• You hear noises or clunks coming from your suspension
• Your steering wheel is not centered when you are going straight

These are all symptoms you should have checked at your vehicle repair facility as soon as you can. The longer you wait, the more damage you may be doing.

You also may find after hitting a pothole hard that the tire on that wheel is flat. Try not to drive any more on that tire since you could do a lot more damage to the tire and/or wheel. A call to roadside assistance may save you money in the long run by limiting the damage to what's already done.

Kingwood Service Center
3318 Northpark Dr
Kingwood, TX 77339
(281) 360-7323
http://www.kingwoodservicecenter.net