AUTONET TV

The Key Won't Turn! (Ignition Problems)

You've just arrived at the store shopping and you're ready to head home.  You put your key in the ignition and… oh, no! The ignition won't turn! What do you do now?

Don't panic.  There are some things you can do to get going again.  The first thing to do is see if you have a locking steering wheel, an anti-theft feature that was introduced around 1970.  Sometimes it sticks.  Move the steering wheel side to side while you try to turn the key and you might be able to get it to release. 

Another thing to check is to see if your vehicle is in gear.  Most vehicles will only allow you to start the ignition if it's in park or neutral.  If you have an automatic transmission vehicle and it is in park, try jiggling the shift lever and try the key again.  Sometimes the safety mechanism doesn't properly make contact or gets a little sloppy. 

If both of these don't work, it could be your vehicle's battery is dead.  Some newer electronic systems require power so the key can turn. Others have alarm systems that detect if doors are open. 

Other issues that can cause key problems include something jammed in the lock cylinder.  Or some of the springs or pins inside may be stuck.  Consider that it may be the key itself.  Sometimes they get bent or simply wear out from the number of times they've been put in and taken out of the cylinder.

No matter what the cause, the first time this happens you should have your repair service facility check it out. That’s because if it happens once, it can happen again.  Even if you were able to get going again on your own, your ignition/key has warned you that something's wrong.  Have it checked out by a pro so you’re not locked into a bad situation.

Kingwood Service Center
3318 Northpark Dr
Kingwood, TX 77339
(281) 360-7323
http://www.kingwoodservicecenter.net

Out with the Old (Vehicle Parts that Wear Out)

Some drivers don't pay any attention to their vehicles until something breaks.  Others take them into their service repair facility for maintenance even before a problem develops.  Still, even if you fit into the second group, there are some parts on a vehicle that will simply wear out over time.

Your vehicle has gaskets in several places.  They use a flexible material to seal the gaps between metal parts that fit together. After time, that material shrinks or gets brittle and fails.  Eventually, after time, you will have to get gaskets replaced.

Same goes for belts.  Your engine has belts that help take the mechanical energy of the engine to drive other parts such as the generator and air conditioner.  Heat and age will eventually cause these belts to wear out or break, so you'll need new ones at some point.

You'll also find yourself buying brake pads.  As much as you may try to go easy on them, brake pads work by wearing off a little bit of them each time they help you stop your vehicle.  Do a lot of stop-and-go driving and you'll hasten the process.

No battery lasts forever, and your vehicle's battery is no exception.  It can only charge and discharge electricity so many times.  Count on getting no more than 4 or 5 years out of a battery, fewer if you live in a very hot spot.

Other parts that don't age well? Tires.  They can have plenty of tread left on them, but rubber gets old and loses its flexibility. Tires have their date of manufacturer stamped on them for a reason.

Finally, your muffler is being subject to moisture from inside and out: inside because of moisture-containing exhaust and outside from the elements outdoors. Stainless steel or other alloys will last longer, but after a while, either the moisture or constant pounding from vibrations will take their toll.

That's why it's important to maintain every part on your vehicle. You can't wave a magic wand and make everything last forever, but take care of your vehicle and it'll take care of you.

Kingwood Service Center
3318 Northpark Dr
Kingwood, TX 77339
(281) 360-7323
http://www.kingwoodservicecenter.net